Autoterm Comfort Control - digital control panel for 12V/24V parking heaters

€508.20*
RRP €509.00* (0% gespart)Delivery time: 3 - 5 Werktage
Thanks to its compact design, the AUTOTERM Air 2D can be easily installed in almost any land or water vehicle and comes with a complete installation kit, whether you choose the 12V or 24V DC version. The unit draws fresh air from outside or from a well-ventilated space and heats it quickly, providing comfort and warmth in cold environments. The heater has a maximum output of 2 kW and can produce up to 86 m³ of warm air per hour while maintaining the desired temperature.
Parking heaters from the manufacturer Autoterm, known by their former name Planar 2D, have become indispensable in motorhomes, caravans and expedition vehicles. They are designed for tough continuous use and are particularly valued for their reliability and safety. Thanks to their low fuel consumption, performance and excellent controllability in various operating modes, they are ideal for travel vehicles on land and water. All Autoterm heaters carry an E-mark. This means that no approval or registration is required to install the heater. It is suitable for all vehicle types. The Autoterm Air 2D is available for vehicles with a 12-volt onboard voltage as well as for vehicles with 24 volts. It is not only travel vehicles that are perfectly equipped for extreme cold with Autoterm Air parking heaters - high altitudes are no problem either. In the past, a reduced oxygen supply in the combustion air quickly led to soot formation in the combustion chamber. In the meantime, however, the heaters have long been equipped with an altitude kit that regulates combustion. Depending on the ambient air pressure, the heater automatically reduces the amount of injected fuel.
Despite the altitude kit, operating a diesel parking heater (like operating a diesel engine in a car) is a technical compromise. Over time, you must ensure that the combustion chamber gets properly hot so that it can burn freely. Otherwise, sooting cannot be avoided even with an altitude kit. However, if you actually stay at an altitude of 4,000 m for several weeks, cleaning the combustion chamber and replacing the seals is possible and justified. Free combustion in the heater is the most important and also the only necessary maintenance for the heater. As at high altitude, the combustion chamber must also be given the opportunity to free itself from soot deposits at normal altitude. Sooting usually occurs when the heater is operated at low output. Therefore, run your heater at full output for half an hour every 1-2 weeks. Think of your heater's combustion chamber like a diesel engine - if it has always been run at low revs, the soot should be removed during a good motorway drive. The same applies to combustion in the heater. The Autoterm parking heater does not disrupt operation throughout your holiday and is extremely reliable. At high altitudes, the heater receives less air and, accordingly, less fuel. Consequently, the heater's maximum output decreases as altitude increases; from 2,000 m, roughly 5% of output is lost per 500 m of altitude.
At high altitudes, free airflow through the blower is particularly important. The combustion air inlet and outlet should be extremely short and low-resistance. Kinks, blockages or restrictions should be avoided.
The input of the heater emergency switch is often used for remote control. All you need to do is connect two wires via a switch or relay. This can be done either permanently, in which case the heater starts and runs until the connection is interrupted again, or via a pulse. In this case, a pulse of 0.5-3 s can be used to switch it on. The next pulse would switch the heater off again. The advantage of the second option is that the heater can be controlled via various controls. For example, it can be switched on via a self-built remote control or a push button and then adjusted in output, or even switched off from bed via an installed controller.
The fuel line included in the kit is usually sufficient. If the hose turns out to be too short, you can order it by the metre.
This is an Autoterm Air 2D with a heating output of 2 kW. The Autoterm Air is also available in a 4D version with 4 kW heating output in 12 V or 24 V. Which model is right for you depends on your travel habits, your destinations and your vehicle's insulation. After all, a heater with double the output costs only slightly more! A 4 kW heater quickly turns smaller motorhomes into a sauna, even at the lowest setting, and you have to open a window while heating. This is not only completely unnecessary, but also leads to faster sooting of the heating system (see above). If in doubt, choose a smaller heater and run it at a higher setting rather than always running a larger heater at a lower setting.
| Gewicht (kg): | 7 |
|---|---|
| Marke: | AUTOTERM |
| Maße: | 40 × 36 × 16 cm |
| Spannung (Volt): | 24 V |